Why bone shrinks after a tooth is lost
Alveolar bone exists because of teeth: it is the tissue that supports them and that is stimulated every time you chew. When a tooth is lost or extracted, that stimulation stops and the bone begins to resorb. The sharpest reduction happens in the first six to twelve months, then it slows down but does not stop.
That is why timing matters so much. A tooth missing for a year leaves a very different situation from one missing for ten: in the second case bone may have gone in both height and width, and the remaining ridge can be too thin to hold an implant.
Some causes speed the process up: untreated gum disease, a chronic infection around a root, a cyst like the one documented in one of the cases in our clinical section. There the bone has not merely receded, it has been destroyed by an active process that must be removed before anything is rebuilt.
How available bone is actually measured
A panoramic X-ray shows height approximately and says nothing about width. To decide whether a graft is needed you need a cone beam CT scan (CBCT), which reconstructs the volume in three dimensions and lets the ridge be measured millimetre by millimetre at the exact spot the implant would go.
The two measurements that count are height — the distance between the ridge and the structures that must not be touched, the alveolar nerve below and the floor of the maxillary sinus above — and width, because bone has to remain all around the implant, not only in front and behind.
Until there is a CBCT, any statement about grafting is a guess. That cuts both ways: it applies to whoever tells you a graft is needed, and to whoever promises you it will not be.
The techniques, from lightest to most demanding
These are not alternatives to pick by price: each answers a specific type of defect, and the choice is made by the surgeon on the basis of the CT scan.
- Guided bone regeneration (GBR) — granular biomaterial and a membrane protecting the site while bone grows back. The most common technique for contained defects.
- Block graft — a fragment of bone fixed with screws, where width is missing over a wider area.
- Lateral window sinus lift — in the posterior upper jaw, when remaining height is very limited.
- Crestal sinus lift — more conservative, when only a few millimetres are missing and can be gained through the socket itself.
- Split crest — the ridge is expanded sideways, where height is adequate but width is not.
- Socket preservation — filling the site immediately after extraction, to limit future resorption.
How much time it adds
It depends on when the graft is done relative to the implant. In many contained cases both are done in the same session: the implant goes in and the bone around it is regenerated at the same time. The extra time is limited, because regeneration and osseointegration run in parallel.
Where the defect is large, the graft comes first and the implant later. That usually adds four to nine months of waiting, during which the regenerated bone has to mature enough to hold an implant. The radicular cyst case documented in our clinical section follows exactly that logic, with the implant placed eight months after the regeneration.
In practice this means a two-stage grafted pathway can take three trips rather than two. Worth knowing before you buy the flights, not after.
What it changes in the quote
A graft is a separate line, distinct from the implant, and its cost depends on the size of the defect and the biomaterial used. A lateral window sinus lift weighs more than a localised GBR around a single implant, simply because it is a longer procedure and uses more material.
It is also the main reason a quote based on a panoramic X-ray alone can change after the CT scan at the clinic. That is not a commercial surprise: it is information that did not exist before. What you can expect is that the possibility be stated in writing in the initial quote, with an estimate, rather than appearing on the day of surgery.
When a graft can be avoided
Not every situation of reduced bone calls for reconstruction. Some solutions use bone where it still is, instead of recreating it where it is missing.
All on 4 exists precisely for this: the two posterior implants are placed at an angle so they rest on denser anterior bone and avoid the maxillary sinus. Short implants follow the same logic, used where remaining height is limited but width is good.
The choice between rebuilding and working around is not ideological. It depends on how much bone is left, on the site, on age and general health — and on the fact that one operation fewer, where it is clinically sound, is nearly always preferable.

