What they have in common
Both protocols solve the same problem: an arch with no teeth, or with teeth that cannot be saved, to be restored with a fixed prosthesis the patient does not remove. In both, the implants are splinted by a single framework, so that chewing load is spread across all of them instead of concentrating on one.
The pathway is the same too: CT scan, any extractions and surgery on the same day, a fixed screw-retained temporary within hours or a few days, months of osseointegration, and finally the definitive prosthesis on a second trip.
The difference is therefore not in the kind of result, but in the number of supports it rests on — and consequently in how much bone is needed to deliver it.
The real difference: how the load is spread
In All on 4 the two front implants are straight and the two rear ones are tilted, usually at thirty or forty-five degrees. The tilt is not a compromise: it moves the emergence point further back, lengthening the prosthesis's base of support without having to enter the posterior bone, which is occupied above by the maxillary sinus and below by the nerve.
All on 6 adds two intermediate implants. The result is a longer base of support with more points of contact, reducing the cantilever — the part of the prosthesis projecting beyond the last implant, which works like a lever.
Mechanically that is the whole of the difference. More implants mean less cantilever and more divided load; but they also mean more bone needed and a more extensive operation, and neither is free.
When four implants are enough
All on 4 was developed precisely for cases where posterior bone is scarce and a graft is to be avoided. Tilting the distal implants makes use of anterior bone, which in the lower jaw is nearly always dense and which in the upper jaw remains available even when the back has resorbed.
It is often the indicated solution for a fully edentulous lower jaw, because anterior mandibular bone offers high primary stability — the condition that most often allows immediate loading with a fixed temporary.
Four well-placed implants in good bone hold better than six badly placed in poor bone. The number on its own is not a quality indicator.
When the surgeon advises six
There are situations where six implants are the more prudent choice. The upper jaw is the first: its bone is more porous than mandibular bone, so spreading the load over more points helps.
- Upper arch with low-density bone, where each individual implant has less stability.
- Very wide arches, where four implants would leave an excessive posterior cantilever.
- Patients with high chewing forces or documented bruxism.
- Sufficient posterior bone volume, making the two extra implants placeable without a graft.
- Cases where a safety margin is preferred: with six implants, losing one does not compromise the whole structure.
The framework matters as much as the implants
Once the number of implants is settled, there is still the prosthesis that screws onto them, and it affects the quote as much as the surgery does. The main options are a titanium framework faced with composite resin, and a zirconia framework.
Resin is lighter and easier to repair if it chips, but it wears and changes colour over time. Zirconia is more stable aesthetically and more wear-resistant, but it is stiffer and costs more.
When comparing two quotes, the first thing worth checking is that they refer to the same material. A marked price gap between two apparently identical proposals nearly always sits here, not in the implants.
What changes in cost and time
Cost rises with the number of implants, but not proportionally: the difference between the protocols is two extra implants and a slightly longer operation, while the framework weighs similarly in both.
On timing the difference is minimal. Surgery takes a few tens of minutes longer, and the months of osseointegration are the same. The number of trips does not change: two, unless preliminary grafts are needed.
If you are comparing quotes, the useful figure is not the price per implant but the price per complete arch, definitive framework included, with the material specified.

